Plastic injection before seaming tin lids must be completely dry, as this may lead to squeeze glue. In cold, high humidity, the sealant can lids are not quickly dried. Good ventilation for sufficient drying is critical. Solvent drying sealant does not require heating, and water-based sealant must be used heating and drying. After Typically, the lid must reach 85% to 95% of the dryness of the tape can be added, on the tray. After dispensing is recommended for at least 48h before the lid is reduced in sealed packaging, transport or seaming, so that it fully dry, discharge volatiles achieve proper film cured.

The solvent used for sealants, operating procedures must comply with the relevant provisions of the Fire Code and labor protection. Solvent-based sealant dispensing of lids emitted residual solvent vapors may accumulate at the note in form flammable or oxygen-deficient environment, it is necessary to pay attention to the lid of the storage environment.

Dongguan City is Connaught Packing Co., Ltd. mainly produce beverage EOE, aluminum easy-open lid, tinplate EOE other products, EOE products using health and safety, non-toxic and tasteless high-quality materials, using American MINSTER punch press high speed production lines, Japan AADA punch and supporting high-speed production line of the lid of advanced inspection equipment, product handsome in appearance fine; design structural precision, good sealing performance, nothing more than diarrhea, not into the air, to ensure product quality and lasting. Welcome to order, large favorably. 0769-28686423 / 0769-22335080 13266285888